If you smell gas, leave, then call 911 and Colorado Springs Utilities at 719-448-4800. Otherwise, check the thermostat, the furnace switch and breaker, the filter and the outdoor vent pipes for snow or ice. If the furnace still won't run, call a technician, and keep cabinet doors open and a faucet dripping so pipes don't freeze.
Key facts
- Gas smell
- Leave now; from outside, call 911 and CSU 719-448-4800
- CO alarm sounding
- Get everyone out, then call 911 and CSU 719-448-4800
- Most common simple fixes
- Thermostat setting or batteries, tripped switch or breaker, clogged filter, blocked vent
- High-efficiency furnaces
- PVC intake/exhaust pipes outside can be blocked by snow or ice
- While you wait
- Open sink cabinets, drip faucets on outside walls, keep garage doors closed
Five safe checks (10 minutes)
- Thermostat. Set to Heat, a few degrees above room temperature, fan on Auto. Replace the batteries if the screen is blank or dim.
- Power. Find the switch near the furnace (it looks like a light switch) and make sure it's on. Check the breaker panel for a tripped furnace breaker; reset it once. If it trips again, leave it off and call.
- Filter. A clogged filter can make the furnace overheat and shut itself off. If it's gray and matted, replace it.
- Vent pipes. High-efficiency furnaces have two white PVC pipes on an outside wall or the roof. After snow or a hard freeze, clear any snow, ice or debris from the ends.
- Furnace door and status light. The lower panel must be fully closed or a safety switch keeps the furnace off. Many furnaces have a blinking light with a code chart on the door; note the pattern for the technician.

Don't relight a pilot or open the burner area if you're not comfortable doing it, and never bypass a safety switch.
Still no heat? Call a local heating pro now.
Phone line opening soonProtect your pipes while you wait
Colorado Springs nights regularly drop well below freezing in winter, and a house without heat can freeze pipes within hours on a single-digit night. While you wait for a repair:
- Open cabinet doors under sinks on outside walls.
- Let a thin stream of water run from faucets on outside walls.
- Keep the garage door shut if water lines run through the garage.
- Use space heaters only with clearance from anything that can burn, never unattended, and plugged directly into the wall.
- Know where your main water shutoff is in case a pipe bursts. See frozen pipes.
What the technician will usually find
- Flame sensor or igniter: the furnace starts, then shuts off within seconds, or never lights. Usually a quick, inexpensive repair.
- Pressure switch or inducer motor: the furnace hums but won't light; common on high-efficiency units and sometimes linked to blocked vents or a frozen condensate line.
- Blower motor or control board: no air moving, or erratic behavior. More expensive.
- Cracked heat exchanger: a safety issue; usually means replacement. Ask to see the evidence (photo or camera) before agreeing.
If the repair quote is large and the furnace is older, read furnace replacement cost before you decide.
What a repair usually costs
National ranges from cost publishers, not Colorado Springs quotes. The fault decides the price, so ask for it in writing before work starts.
| Job | National range | Source |
|---|---|---|
| Furnace repair | $349 to $650 | Fixr, updated Aug 2025 |
When you call: 4 questions to ask
- Is the diagnostic or trip fee credited toward the repair?
- Will you size a new system with a load calculation and set it up for our altitude?
- Is the PPRBD mechanical permit included, and what's your PPRBD license number?
- Does this model qualify for the Colorado Springs Utilities rebate, and who files it?
A fair written quote shows model numbers and efficiency, altitude setup, the permit and inspection, removal of the old unit, and parts and labor warranty. Check any contractor's license on pprbd.org before work starts.
What happens when you call
- You're connectedStraight to a local heating & cooling pro that serves your area and takes calls like yours.
- You get a priceDescribe the problem, ask for a written quote and their license number. No obligation.
Common questions
How much does furnace repair cost in Colorado Springs?
Most heating and cooling repairs in Colorado Springs run about $150–$650 in 2026. Flame sensors and igniters sit at the low end; inducer motors, blower motors and control boards at the high end. Ask for the price before work starts and whether the diagnostic fee is credited toward the repair.
Why does my furnace turn on and then shut off right away?
A dirty flame sensor is the most common cause: the furnace lights, can't confirm the flame, and shuts off for safety. A technician can clean or replace it quickly. A clogged filter or blocked vent can cause similar short cycling.
How fast can pipes freeze without heat?
It depends on the outside temperature and where pipes run. On a single-digit night, pipes in outside walls, crawlspaces or garages can freeze within a few hours, so open cabinets and drip faucets while you wait.
Should I call Colorado Springs Utilities if my furnace stops?
Only for a gas smell or a gas or electric outage. For a furnace that simply won't run, call a heating contractor.
Related guides
Sources
- Colorado Springs Utilities: Natural gas incident response (emergency line 719-448-4800)
- National Weather Service Pueblo: Colorado Springs January normals
- National Weather Service Pueblo: January 2025 review (10th-coldest January on record)
- Colorado Springs Utilities: HVAC & heat pump rebates
- ConsumerAffairs: HVAC companies in Colorado Springs: 2026 repair and replacement costs
Costs are typical ranges. Your quote depends on your home. Rules and rebates change; check the original source before you rely on a figure. Something wrong? Tell us via the contact on the Impressum page.