Local Repair FinderSalt Lake City home repair guide

Water heater leaking in Salt Lake City: what do you do now?

Salt Lake City & Salt Lake County · Reviewed November 2026 · Checked against 7 public sources

Close the cold-water valve above the tank. That stops the refill. On an electric heater, switch its breaker off. On a gas heater, leave the gas controls to the plumber. Then look at where the water starts: a fitting on top can often be repaired, while water from the tank's base usually means a new heater. Nationally, a gas tank model runs $900 to $3,000 installed.

Key facts

First move
Cold supply valve closed, at the top of the tank
Gas smell
Enbridge Gas Utah, 1-800-767-1689, and 911
Plumbing license
P200 General Plumbing or P201 Residential Plumbing (Utah DOPL)
Permit
City requires one to install or alter plumbing systems; water heaters are not named
New gas tank heater
$900–$3,000 installed (national, Fixr)
2026 Enbridge rebates
$100 storage, $300 tankless, $350 condensing or gas hybrid

What is it usually?

SymptomLikely causeYour move
Drip at a pipe joint on topLoose or corroded connectionSupply off. A plumber can often repair it
Water from the side pipe that points at the floorRelief valve releasing pressureDon't cap it or touch it. Call
Trickle from the tap near the bottomDrain valve not sealingBucket under it. Call
Water seeping from under the tankTank has rusted throughSupply off, power off. Plan a replacement
Damp ring, no clear sourceCondensation or a slow fitting leakDry it. Check again in an hour

What can you safely do right away?

  1. Shut the cold supply. Follow the cold pipe into the top of the heater. Turn the handle clockwise, or swing a lever a quarter turn so it sits across the pipe. Stuck? Use the main water shutoff for the house.
  2. Cut the power on an electric unit. Flip the water heater breaker to Off, standing on a dry floor. Gas unit? Don't touch the gas control or the burner area. Tell the plumber it is gas when you call.
  3. Water and power both off? Now call a local plumber. Carry on with the cleanup steps in the meantime.

    Phone line opening soon

    Have this ready when you call

    • Your address
    • Where the water is and whether the main is off
    • When it started
  4. Trace the water. Wipe the tank dry with a towel. Watch for a minute. Top, side, drain tap or base? That answer shapes the whole repair.
  5. Protect the room. Lift boxes, rugs and anything cardboard. Mop toward a floor drain if there is one.
  6. Take pictures. Photograph the heater's label, the leak point and the wet floor. Your plumber and your insurer will both ask.
Water pooling in a drain pan around the base of a water heater

When should you stop and call a pro?

  • Water comes from the base of the tank.
  • The relief valve pipe is discharging.
  • The supply valve won't close or keeps dripping past.
  • Water has reached an outlet, the breaker panel or the furnace.
  • You smell gas. Leave first, then call the gas line below.
  • The tank rumbles, pops loudly or is hot to the touch on the outside.

Draining a tank, changing a valve and reconnecting gas or wiring are plumber jobs. So is anything on the relief valve.

Want a price for your home? Call a local plumber for a written quote.

Phone line opening soon

What if you smell gas near the heater?

Get everyone out. No light switches, no phone calls from indoors, no car started in the driveway. From a safe distance, ring Enbridge Gas Utah's emergency line at 1-800-767-1689, and 911. The gas utility comes before the plumber.

Does a new water heater need a permit in Salt Lake City?

Building Services states that installing or altering plumbing systems requires a permit. The city's pages do not name water heaters. So this guide can't give you a flat yes. Ask the plumber whether a permit is being pulled for your job, and ask the city if you want it confirmed.

Which license covers this?

Utah licenses plumbers at journeyman and master level, plus plumbing contractors under P200 General Plumbing and P201 Residential Plumbing. All of it runs through DOPL. Check the name on the DOPL lookup while you wait for the truck.

What will a repair or replacement cost?

No verified local repair price is in this guide. For replacement, Fixr's national range for a natural gas tank water heater is $900 to $3,000 installed. That is a national figure. Enbridge Gas Utah's 2026 rebates can trim it: $100 for a high-efficiency gas storage model, $300 for gas tankless, $350 for gas condensing storage or a gas hybrid. See the water heater cost page.

Who handles the wet floor?

A plumber fixes the heater. Soaked drywall, carpet pad or subfloor is drying work. Angi's typical Salt Lake City range for water damage restoration is $650 to $5,900. The steps are on water damage first steps.

What a repair usually costs

National ranges from cost publishers, not Salt Lake City quotes. The fault decides the price, so ask for it in writing before work starts.

JobNational rangeSource
Water heater repair$150 to $750Fixr, updated Aug 2025

When you call: 4 questions to ask

  1. What's the trip or diagnostic fee, and is it applied to the job?
  2. Is the price flat-rate or hourly, and what's the total before you start?
  3. Is the city permit included in the price?
  4. What's your Utah DOPL plumbing license number?

A fair written quote shows the parts list, labor, permit, haul-away of old equipment, and the warranty in writing. Check any contractor's license on Utah's DOPL lookup before work starts.

What happens when you call

  1. You're connectedStraight to a local plumber that serves your area and takes calls like yours.
  2. You get a priceDescribe the problem, ask for a written quote and their license number. No obligation.

Common questions

Is a leaking water heater an emergency?

Treat it as one until the water supply to the tank is closed. After that, a slow leak can usually wait for a scheduled visit. A leak from the tank's base, or any gas smell, should not wait.

Can a leaking water heater be repaired?

Sometimes. Leaks at top fittings and at the drain valve are often repairable. Water coming from under the tank usually means the tank itself has failed.

How do I turn off the water to my water heater?

Use the valve on the cold pipe entering the top of the tank. Turn a round handle clockwise, or swing a lever so it sits crosswise to the pipe. If it is stuck, close the main shutoff.

Does Enbridge give a rebate on a replacement water heater?

In 2026, yes, for qualifying gas models: $100 high-efficiency storage, $300 tankless, $350 condensing storage or gas hybrid.

Related guides

Sources

  1. Enbridge Gas Utah: Smell gas?
  2. Salt Lake City Building Services: Frequently asked questions
  3. Utah Legislature: Utah Code 58-55-301, license classifications
  4. Utah Division of Professional Licensing: Apply for a general contractor license
  5. Fixr: Water heater installation cost
  6. Enbridge Gas Utah: 2026 ThermWise appliance rebates, water heating (Utah)
  7. Angi: Water removal and recovery cost in Salt Lake City, UT

Costs are typical ranges. Your quote depends on your home. Rules and rebates change; check the original source before you rely on a figure. Something wrong? Tell us via the contact on the Impressum page.