Local Repair FinderSan Antonio home repair guide

Furnace not working in San Antonio

San Antonio & Bexar County · Reviewed November 2026 · Checked against 11 public sources

If you smell gas, leave the house now and call 911 and CPS Energy at 210-353-4357 from somewhere else. With no gas smell, check that the thermostat is on Heat, the filter is clean, the furnace switch is on and the breaker has not tripped. San Antonio's normal January low is 41 °F, so most cold nights allow time for a daytime visit, but a hard freeze changes that.

Key facts

Gas smell
Leave, then 911 and CPS Energy 210-353-4357
First check
Thermostat on Heat, set above the room reading
Then
Filter, furnace switch, one breaker reset
License to ask for
TDLR Air Conditioning and Refrigeration contractor
New gas furnace
$3,800–$10,000 installed (national, Fixr)
Gas furnace rebate
None on CPS Energy's current list
Normal January low
41 °F (National Weather Service)

Before you call

  1. Thermostat. Heat mode, with the target above the temperature displayed. Replace the batteries if the screen is faint or empty.
  2. Filter. Take it out and look. Heavy dust can make a furnace overheat and shut itself down for protection. Swap in a fresh one.
  3. Furnace power switch. Near the unit there is often a plain wall switch that looks like one for a light. It gets bumped off during storage runs to the attic or closet. Make sure it is up.
  4. Breaker. Find the one marked furnace or heat. If it has tripped, turn it Off and back On, one time.
  5. Thermostat, filter, switch and breaker all checked and the house is still cold? Call a local heating company, then read the rest.

    Phone line opening soon

    Have this ready when you call

    • Your address
    • What the system is doing (no heat, no cooling, a noise, a leak)
    • Roughly how old the unit is
  6. Registers. Walk the house and open closed vents; clear boxes or furniture off the return air grille.
Basement furnace with its front panel removed

What to tell the company

  • Gas or electric heat, and whether you have a furnace or a heat pump, if you know.
  • What the system does: nothing at all, fan with cold air, or starts and quits after a minute.
  • Any blinking light or code visible through the furnace's small window, read from outside the cabinet.
  • Which checks you ran and whether the breaker tripped.
  • Whether anyone in the home is especially at risk in the cold.

Stop points

Stop and call a pro when:

  • A carbon monoxide alarm sounds. Get everyone outdoors and call 911.
  • You notice a gas odor at any point. CPS Energy's instructions are to exit immediately, leave the door open on the way out, and call from another location.
  • The breaker trips twice.
  • The furnace starts, runs briefly and shuts off, over and over.
  • There is soot, scorching, a burning smell or water around the unit.

Leave the gas valve, the pilot and the burner compartment to a technician.

Winter in a hot city

Cooling gets most of the attention here, and a furnace can sit idle for months before the first cold front. With a normal January low of 41 °F, a failed furnace is usually a comfort problem. The Bexar County hazard plan of 2017 still lists winter storm as a Moderate risk, and in a hard freeze your pipes are at stake too: see frozen pipes.

CPS Energy and gas service

CPS Energy supplies both natural gas and electricity in San Antonio. One number, 210-353-4357, covers gas emergencies, electric emergencies and service problems. CPS asks customers not to report gas leaks by email.

Permit and license

If the answer turns out to be a new furnace, the city's Home Remodeling FAQ says installing HVAC equipment requires a permit, and the residential permits page says homeowners must use licensed trade contractors for new HVAC components. Heating contractors hold a license under TDLR's Air Conditioning and Refrigeration Contractors program; check it on the TDLR License Data Search.

Cost and rebate figures

No San Antonio repair price is available to this guide. Fixr's national figure for an installed natural gas furnace is $3,800 to $10,000. CPS Energy's current residential rebate list shows no gas furnace rebate; a heat pump is listed at $90 to $310 per ton. More on the replacement cost page.

What a repair usually costs

National ranges from cost publishers, not San Antonio quotes. The fault decides the price, so ask for it in writing before work starts.

JobNational rangeSource
Furnace repair$349 to $650Fixr, updated Aug 2025

When you call: 4 questions to ask

  1. Is the diagnostic or trip fee credited toward the repair?
  2. Will you size a new system with a load calculation rather than copying the old unit?
  3. Will you pull the City of San Antonio mechanical permit, and what's your TDLR air conditioning contractor license number?
  4. Does this equipment qualify for a CPS Energy rebate, and who files it?

A fair written quote shows model numbers and efficiency ratings, the permit, removal of the old unit, and parts and labor warranty. Check any contractor's license on the TDLR license search before work starts.

What happens when you call

  1. You're connectedStraight to a local heating & cooling pro that serves your area and takes calls like yours.
  2. You get a priceDescribe the problem, ask for a written quote and their license number. No obligation.

Want a price for your home? Call a local heating & cooling pro for a written quote.

Phone line opening soon

Common questions

Why is my furnace blowing cold air?

Check that the thermostat is on Heat and the fan is on Auto, not On. A clogged filter can also make the furnace shut its burners off while the fan keeps running. If both are fine, it needs a technician.

Who do I call for a gas smell in San Antonio?

Leave first. From another location call 911 and CPS Energy at 210-353-4357. Stay away until you are told it is safe to return.

Is a broken furnace an emergency in San Antonio?

A gas smell or a carbon monoxide alarm always is. Otherwise it depends on the weather and who lives in the home. The normal January low is 41 °F, but hard freezes do happen.

How much does a new furnace cost in San Antonio?

For a new furnace, this guide has only a national figure: Fixr puts an installed natural gas furnace at $3,800 to $10,000. Get a written quote for your own house.

Related guides

Sources

  1. CPS Energy: Natural gas safety FAQ
  2. CPS Energy: Contact us
  3. National Weather Service Austin/San Antonio: San Antonio monthly normals
  4. Bexar County Hazard Mitigation Plan 2017 (attached to Leon Valley Ordinance 2017-58)
  5. City of San Antonio Development Services: Home Remodeling FAQ
  6. City of San Antonio Development Services: Residential permits
  7. Texas Department of Licensing and Regulation: Air Conditioning and Refrigeration Contractors forms
  8. Texas Department of Licensing and Regulation: License Data Search
  9. Fixr: Furnace cost
  10. CPS Energy: Residential rebates and programs
  11. CPS Energy: HVAC rebates

Costs are typical ranges. Your quote depends on your home. Rules and rebates change; check the original source before you rely on a figure. Something wrong? Tell us via the contact on the Impressum page.