First work out which kind of heater you have. Electric: check the breaker and reset it once. Gas: look for a gas smell first; if there is one, leave and call CenterPoint Energy and 911. In a Minneapolis winter, with a normal January low of 8.8 °F, a frozen supply line can also stop hot water. Gas-fired work is for a licensed pro.

Key facts
- Electric heater
- Breaker, one reset
- Gas heater
- Gas smell? Leave; CenterPoint 800-296-9815 or 612-372-5050, and 911
- Only some taps cold
- Frozen line or a fixture problem
- January normal low
- 8.8 °F (Minneapolis-St. Paul airport, 1991–2020)
- Permit to replace
- City of Minneapolis plumbing permit
- Tankless rebate
- $500 from CenterPoint, replacement, 0.87 UEF or greater (2026)
Start with one question: where is it cold?
- Every hot tap is cold. The heater itself, its power or gas, or its controls.
- One fixture is cold. That fixture's valve or a frozen pipe on its run, often on an outside wall.
- Hot water runs out fast. A worn element, sediment or an undersized tank.
- No water at all. A frozen or broken supply; see frozen pipes.
Checks by heater type
| Check | Electric heater | Gas heater |
|---|---|---|
| Power | Breaker tripped? Reset once. If it trips again, stop. | Power vented models plug in: check the outlet and breaker. |
| Fuel | Not applicable | Other gas appliances working? If none are, call CenterPoint Energy. |
| Controls | Leave the element covers closed | Look at the status light; don't open the burner area |
| Venting | Not applicable | Outdoor vent pipe clear of snow and frost |
| Leaks | Water at the base means replacement is likely | Same, plus any gas smell means leave first |
Want a price for your home? Call a local plumber for a written quote.
Phone line opening soonThe gas rule in Minneapolis
Owner-occupants in Minneapolis can do their own plumbing or mechanical work, but the City's permit applicants page says homeowners are not allowed to work on gas-fired heating equipment. Treat the gas controls and burner of a water heater as off limits unless the City tells you otherwise. CenterPoint Energy's gas leak advice is simple: leave on foot, then call CenterPoint at 800-296-9815 or 612-372-5050 and 911 from a safe spot.
When it is time for a new heater
The City lists replacing or installing a water heater as work that needs a plumbing permit, and the plumber must be licensed or registered with the Minnesota Department of Labor and Industry. Fixr's national average range for a tank-style gas heater is $1,000 to $2,700 installed. CenterPoint Energy pays $500 in 2026 for a replacement tankless gas unit at 0.87 UEF or greater.
Cold-weather causes
With a normal January low of 8.8 °F at the airport (NOAA, 1991–2020), the hot line to a bathroom over a garage or on an outside wall can freeze even when the heater is fine. If the cold tap at that fixture also stops, it is likely a frozen pipe rather than the heater.
What a repair usually costs
National ranges from cost publishers, not Minneapolis quotes. The fault decides the price, so ask for it in writing before work starts.
| Job | National range | Source |
|---|---|---|
| Water heater repair | $150 to $750 | Fixr, updated Aug 2025 |
When you call: 4 questions to ask
- Who pulls the City plumbing permit for the water heater?
- Is this tankless unit 0.87 UEF or greater for CenterPoint's rebate?
- Are you licensed or registered with the Minnesota Department of Labor and Industry?
- If the problem is under the street, can you show me on camera where it is?
A fair written quote shows the equipment, labor, the permit, haul-away of the old unit and written warranty terms. Check any contractor's license on the Minnesota DLI license lookup before work starts.
What happens when you call
- You're connectedStraight to a local plumber that serves your area and takes calls like yours.
- You get a priceDescribe the problem, ask for a written quote and their license number. No obligation.
Common questions
Why do I have no hot water but cold water works?
Usually the heater has lost power or gas, a safety control has shut it down, or the heater has failed. If only one fixture is cold, suspect a frozen or blocked line to it.
Can I relight my gas water heater in Minneapolis?
Follow the lighting instructions on the heater's label. If the pilot won't stay lit, call a licensed plumber. If you smell gas, leave first, then call CenterPoint Energy and 911.
What does a new water heater cost?
Fixr's national average range for a tank-style gas water heater is $1,000 to $2,700 installed.
Is a permit needed to replace it?
Yes. The City of Minneapolis requires a plumbing permit to replace or install a water heater.
Related guides
Sources
- Minnesota DNR State Climatology Office: NOAA NCEI Local Climatological Data, Minneapolis-St. Paul International Airport, 2022 (1991–2020 normals)
- City of Minneapolis: Permit applicants
- CenterPoint Energy: What to do if you smell gas
- CenterPoint Energy (Minnesota): Stay safe
- City of Minneapolis: Plumbing permits
- Minnesota Department of Labor and Industry: Choosing a plumber
- Fixr: Gas water heater installation cost
- CenterPoint Energy (Minnesota): Water heater rebates, 2026
Costs are typical ranges. Your quote depends on your home. Rules and rebates change; check the original source before you rely on a figure. Something wrong? Tell us via the contact on the Impressum page.