Local Repair FinderMinneapolis home repair guide

Water heater leaking in Minneapolis

Minneapolis & the Twin Cities · Reviewed November 2026 · Checked against 8 public sources

Turn off the water feeding the heater first: the valve on its cold inlet, or the main by the meter. Electric model? Its breaker goes off too. Gas model? Leave the burner and gas controls for the plumber, and if there is any gas odor, get out and phone CenterPoint Energy and 911. Replacement needs a City plumbing permit; Fixr's national figure for a gas tank unit is $1,000 to $2,700.

Key facts

Stop the water
Inlet valve on the cold side, or the main by the meter
Electric unit
Its breaker off
Gas unit
Hands off the gas valve and burner
Gas odor
Out of the house; CenterPoint 800-296-9815 or 612-372-5050, and 911
To replace
City of Minneapolis plumbing permit
Gas tank unit, installed
$1,000–$2,700 (Fixr, national average range)
  1. Close the inlet. Follow the cold pipe into the heater and turn its valve clockwise. If it won't budge, go to the basement main by the meter.
  2. Take away the heat source safely. On an electric unit, flip its breaker off. On a gas unit, don't turn knobs on the gas control. An odor of gas means everyone leaves first.
  3. Valve closed, but the tank keeps weeping? Phone a Minneapolis plumber now and work through the rest while you wait.

    Phone line opening soon

    Have this ready when you call

    • Your address
    • Where the water is and whether the main is off
    • When it started
  4. Pin down where it's coming from. Wipe the heater dry, wait a few minutes, and look again. A wet fitting overhead, a dribble from the relief pipe, a weeping drain spigot, or water seeping from under the jacket all point different ways.
  5. Save what's nearby. Lift boxes off the floor, lay towels and get air moving.
  6. Snap the rating plate on the side of the heater, plus the puddle, for the plumber and your insurer.
Water pooling in a drain pan around the base of a water heater

Read the leak

  • Overhead pipe joints: Corrosion or a loose union. Frequently repairable, and with the inlet off it can usually wait for a weekday visit.
  • Relief valve discharge pipe: The valve is releasing pressure or heat, or it's worn out. Have it looked at soon, and never plug that pipe.
  • Drain spigot near the floor: Not seated, or the washer is tired. A quick fix in many cases.
  • From under the jacket or the base pan: The tank has given out. Plan on a new heater.

A new heater in Minneapolis

The City counts "Replace or install a water heater" among jobs that need a plumbing permit, per its plumbing permits page. Anyone doing the work for pay must be licensed or registered with the Minnesota Department of Labor and Industry, which you can confirm on the DLI license lookup. For pricing, Fixr's national average range for a tank-style gas unit installed is $1,000 to $2,700. Going tankless at 0.87 UEF or greater earns $500 from CenterPoint Energy on a 2026 replacement; the cost page has the conditions.

Thinking of swapping it yourself? Minneapolis lets an owner who lives in a single-family home do their own plumbing under a permit, yet it also forbids homeowners from working on gas-fired heating equipment. If yours burns gas, get the City's answer before you start.

What a repair usually costs

National ranges from cost publishers, not Minneapolis quotes. The fault decides the price, so ask for it in writing before work starts.

JobNational rangeSource
Water heater repair$150 to $750Fixr, updated Aug 2025

When you call: 4 questions to ask

  1. Who pulls the City plumbing permit for the water heater?
  2. Is this tankless unit 0.87 UEF or greater for CenterPoint's rebate?
  3. Are you licensed or registered with the Minnesota Department of Labor and Industry?
  4. If the problem is under the street, can you show me on camera where it is?

A fair written quote shows the equipment, labor, the permit, haul-away of the old unit and written warranty terms. Check any contractor's license on the Minnesota DLI license lookup before work starts.

What happens when you call

  1. You're connectedStraight to a local plumber that serves your area and takes calls like yours.
  2. You get a priceDescribe the problem, ask for a written quote and their license number. No obligation.

Want a price for your home? Call a local plumber for a written quote.

Phone line opening soon

Common questions

How urgent is a leaking water heater?

With the inlet closed, a slow drip from an overhead joint can usually wait for a weekday visit. Water seeping from the tank itself, a relief valve that won't stop, or a whiff of gas cannot.

Will closing the heater's valve cut off all my water?

No. Shutting the inlet to the heater only stops the hot side. Cold taps keep running.

Is a permit required for a new water heater in Minneapolis?

Yes. The City puts replacing or installing a water heater on its list of work that needs a plumbing permit.

Can I get money back on a replacement?

CenterPoint Energy's 2026 water heater rebate is $500 for a tankless gas model rated 0.87 UEF or greater replacing an existing heater, for its Minnesota customers.

Related guides

Sources

  1. CenterPoint Energy: What to do if you smell gas
  2. CenterPoint Energy (Minnesota): Stay safe
  3. City of Minneapolis: Plumbing permits
  4. City of Minneapolis: Permit applicants
  5. Minnesota Department of Labor and Industry: Choosing a plumber
  6. Minnesota Department of Labor and Industry: License lookup
  7. Fixr: Gas water heater installation cost
  8. CenterPoint Energy (Minnesota): Water heater rebates, 2026

Costs are typical ranges. Your quote depends on your home. Rules and rebates change; check the original source before you rely on a figure. Something wrong? Tell us via the contact on the Impressum page.