A breaker that trips is doing its job. Unplug everything on that circuit, push the handle fully off and back on once, then plug things in one by one to find what overloads it. If it trips with nothing connected, or you notice heat, buzzing or a burning smell at the breaker box, leave it off and call an electrician. In Nashville a local electrical license is required whatever the job size.

Key facts
- Safe sequence
- Unplug, reset once, reconnect one item at a time
- Leave it off when
- It trips with nothing plugged in, or the box is warm or smells
- Whole house dark
- NES outage line, 615-234-0000
- License
- Local license required regardless of project amount (state LLE page)
- Permit
- Service size increase: yes (Metro's permit chart)
- 200 amp service upgrade
- $1,800–$4,500 (national, Fixr)
Short version: take the load off, reset one time, add things back slowly; a breaker that still won't hold is telling you to call an electrician.
What you can check
- Identify the circuit. Open the breaker box door and find the handle that's out of line with its neighbours. Read the label beside it, then note which rooms and outlets went dead.
- Unplug the lot. Disconnect everything on those outlets and turn off the lights on that circuit. Space heaters, hair dryers, microwaves, kettles and window air conditioners are the usual heavy hitters.
- Reset once. With dry hands, press the handle firmly to off, then to on. If it snaps back straight away with nothing connected, stop here; the fault is in the wiring or the breaker.
- Reconnect in stages. Plug in and switch on one item, wait, then the next. The device that trips it, or the combination that does, is your answer.
- Spread the load. If two big appliances were sharing the circuit, run them at different times or move one to an outlet in another room.
- Press the test and reset buttons. Outlets in kitchens, bathrooms, garages and outdoors often have their own buttons, and one tripped outlet can silence several others downstream. Push reset until it clicks.
Want a price for your home? Call a local electrician for a written quote.
Phone line opening soonWhat not to touch
The metal cover behind the breaker box door stays screwed on; the parts behind it are live even with breakers off. Never swap a breaker for a higher-rated one, tape or wedge a handle in place, or keep resetting to see if it "takes". A scorched plug or outlet goes out of service, not back into use.
Stop and call a pro when:
- the breaker trips instantly or won't latch;
- the breaker, the box or an outlet cover feels warm;
- you hear crackling or buzzing, or smell hot plastic;
- lights dim or flicker around the house when an appliance starts;
- the main breaker is the one tripping;
- water has got into the box or an outlet.
Smoke or flame at the box is a 911 call, made from outside.
The Nashville part
NES. If every circuit is dead and no breaker has moved, look at the street. An outage is reported to Nashville Electric Service on 615-234-0000, or by texting OUT to 637797 from a mobile phone tied to your NES account. NES looks after its lines; wiring inside the house is an electrician's work.
License. Tennessee's Limited Licensed Electrician page says that state license covers work costing less than $25,000 and that the local license is required regardless of the project amount. It also says the LLE isn't accepted where a local jurisdiction has its own licensing and inspections, which Metro Nashville does. Ask for the Metro electrical license; for work of $25,000 or more a state contractor license applies, searchable on Tennessee's license search.
Metro Codes. Metro's permit chart answers "yes" for increasing electrical service size and for relocating a fixture, switch or outlet. It has no row for replacing a single breaker or a same-size panel, and it was last revised in 2011. Put the question to Permit Issuance on 615-862-6517 or Electrical Inspections on 615-862-6528, both at Metro Codes and Building Safety.
Cost. There is no Nashville price in this guide for a diagnostic visit, a new breaker or an added circuit; a national breaker range is below. If the electrician says the service is too small for the house, Fixr's national figure for a 200 amp upgrade is $1,800 to $4,500; the panel upgrade page has more.
Heat and cold. Nashville's normal July high is 90.9 °F and its normal January low 30.1 °F. Window units in summer and plug-in heaters in winter are both heavy loads, so tripping that follows the seasons often traces back to one of them.
What a repair usually costs
National ranges from cost publishers, not Nashville quotes. The fault decides the price, so ask for it in writing before work starts.
| Job | National range | Source |
|---|---|---|
| Replacing a circuit breaker | $100 to $260 | HomeGuide |
When you call: 4 questions to ask
- Which local and state electrical licenses do you hold?
- Will you get the Metro permit for increasing the service size?
- Is there room in the panel for a heat pump or charger later?
- Is the trip charge credited on the job?
A fair written quote shows the panel, labor, the permit and inspection, with extra wiring priced separately. Check any contractor's license on the Tennessee license search before work starts.
What happens when you call
- You're connectedStraight to a local electrician that serves your area and takes calls like yours.
- You get a priceDescribe the problem, ask for a written quote and their license number. No obligation.
Common questions
Why does my circuit breaker keep tripping?
Three usual reasons: too many things running on one circuit, a faulty appliance, or a wiring or breaker fault. Unplugging everything and adding items back one at a time separates the first two from the third.
Is it dangerous to keep resetting a breaker?
Yes. Reset once. Repeated resets push current through a fault and can overheat wiring. If it won't hold, leave it off.
Do electricians need a license in Nashville?
Tennessee's licensing page says the local license is required regardless of the project amount, and Metro Nashville has its own electrical exam. State contractor licensing applies at $25,000 or more.
How much does it cost to fix a tripping breaker in Nashville?
The guide has no Nashville figure for that repair; a national range for replacing a breaker is on this page. If the fix is a larger service, Fixr's national figure for a 200 amp upgrade is $1,800 to $4,500.
Related guides
Sources
- Nashville Electric Service: Help and FAQs (outage reporting)
- Tennessee Department of Commerce and Insurance: Who needs a Limited Licensed Electrician (LLE) license
- Tennessee Department of Commerce and Insurance: License search
- Metro Codes: Building Permit Required? chart
- Metro Codes: Renovate a single-family residence
- Metro Codes and Building Safety: Contact information
- Fixr: Electrical panel upgrade cost (national)
- National Weather Service Nashville: Nashville (BNA) climate normals and records
Costs are typical ranges. Your quote depends on your home. Rules and rebates change; check the original source before you rely on a figure. Something wrong? Tell us via the contact on the Impressum page.